![extend vector line vcarve pro 9 extend vector line vcarve pro 9](https://i.ytimg.com/vi/Ue2R8aL91Sg/maxresdefault.jpg)
Hopefully no extra attachment mechanism is needed to hold the camera. The main circle shape is sized for a friction fit of the camera. The other interesting feature of the design is the pocket needed for the camera. You can see this with a X-Ray view of the joint. The tenon piece was modeled so that the top and bottom will extend past the slot and cover the dead space in the slot. This means the tenon piece will not be able to go to the ends of the slot. They will all have the radius of the router bit. It’s worth noting that because a router bit is being used to create the slot there will not be any sharp interior corners. The width of the slot needs to be set to the thickness of the material. 25” mortise, or slot, cut into it to hold the base of the arm. This design has a vertical piece that will be screwed to the wall. I won’t cover designing the arm itself because it’s basic modeling back and forth until a desired design is found. Before going to the computer I took measurements for the overall dimensions of the board as well as the location of all the defects.įirst up on the computer is SketchUp. There are two cracks and one chunk of chipout that I need to avoid though. In this case I’m making two arms out of a single piece of mahogany that is perfect for the majority of the board. Of course if you are using a previously used engineered panel you will have to take into consideration the previous cuts. When working with plywood, MDF, or any other engineered panel you typically do not have to worry about defects. It worked much better but I realized this step was unnecessary as I would be sanding the pieces on the final project. The second arm was cut with a slight change in tolerances in the VCarve toolpath settings. Once assembled I noticed it was just too tight to work easily. The first arm was cut out with crappy scrap plywood just to see if I had the workflow figured out.
#EXTEND VECTOR LINE VCARVE PRO 9 SOFTWARE#
But it’s a fun exercise in both design and software workflow.Įverything I’m showing you here is actually the third and final run of the project. The project itself is a movable arm for the baby camera in my daughter’s room.
![extend vector line vcarve pro 9 extend vector line vcarve pro 9](https://docs.vectric.com/docs/V9.0/shared/logos/VCarvePro.png)
The objective of this project was to get a little more familiar with and demonstrate the workflow between SketchUp to VCarve to CNC machine.
![extend vector line vcarve pro 9 extend vector line vcarve pro 9](https://docs.vectric.com/docs/V9.0/VCarvePro/ENU/Help/Drawing/Snapping/Snapping0.png)
Whiteside RFTD2100 downcut spiral flush trim router bit.Whiteside RD2100 downcut spiral router bit.